If you think that the burner isn't on because you can't hear the familiar sound, remove your cover plate to confirm that you can't see the burner firing. This is where we can move on and check the interior door panel for the directions to find out how to turn on gas water heater pilot light.
We want to put the heat to the minimum.
How to turn on hot water heater pilot light. Now, remove the access panel on your water heater to see if the pilot light is indeed out. How you turn on your water heater depends on the type of water heater you have. Most modern water heaters no longer use standing pilots.
This makes it one of the ways that you can make use of the pilot mode. Click to see full answer. Now off the regulator valve.
Tankless water heaters are becoming more common. But first, check for a gas leak. Once in the pilot position, press the control knob down fully and keep holding it down for 30 seconds.
If that’s clear, you can proceed. How to turn your water heater pilot light back on. While still holding the gas down, light that pilot.
If you have trouble locating it, it’s usually located at the front of the water heater. If there’s a leak, then igniting a flame can cause an explosion. Turn the gas knob to “pilot,” press and hold it down.
The tank fills up with water, and the heating elements in the tank warm the water. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. Then, turn the pilot dial until it says the word pilot.
Sniff around the pilot light area and make sure you don’t smell any gas. The one that has “on”, “off”, and “pilot” markings on it. Once you confirm that you're not getting a light, move to your temperature dial.
While holding the control button down, press. On most hot water heaters this is a small flame or spark symbol. Turn the dial to vacation or low.
This will start the flow of gas so you can light the flame. Also when you are planning to go away for some period during winter, then you can leave your hot water tank on a pilot mode. First things first, try to light it again before assuming there is a major problem.
Press and hold the reset or pilot button on the control box until the pilot lights and continue to hold it for 60 seconds after the pilot is lit.rebuilding of the heater should not be attempted, especially if the unit.repeat the process once if the pilot did not light the first time. First locate the temperature controls. Your first step is obvious:
Look out for two small gas tubes, which should lead directly to the pilot light burner. If your hot water heater is a manual, grab a long lighter. Go back to the gas valve and turn the knob to “pilot.” by pushing the knob down, you will start the flow of gas to the pilot.
You just simply leave your hot water tank on the pilot and you will find the water warm when you come back. It’s easy to turn your water heater pilot back on. When relit, the water heater pilot light flame should wrap around the thermocouple bulb.
Here's how you want to troubleshoot: The below video will demonstrate how to light your water heater pilot light. They use electronic ignition to ignite the gas.
Do not attempt to manually light an electronic ignition system. Be careful with this step, because gas will flow once you turn the knob to “pilot”. Once the pilot lights, keep holding the knob/button down for around one.
While still holding down the knob or button, use an extended lighter to reach into the access and ignite the pilot. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks. Turn the control valve to “on”.
To relight the pilot, turn the knob to the pilot position. Pilot lights depend on the electric signal from a thermocouple to stay on, and the thermocouple in turn depends on the heat of the pilot light to provide that signal. After you have located the pilot light burner, turn the gas knob from “off” to “pilot”.
After removing the metal plate covering the pilot button, scan the interior and find the pipe or pipes that lead up to the burner. To turn it off, simply press on it and rotate until the arrow points to the off position. Common types of water heaters.