There are two types of drill bits recommended to drill through a tile. Seal the holes using a silicone sealant.
This task may seem daunting at first but we are here to show you how it is done.
How to drill into tiles bathroom. Wait for the area you’ve drilled to dry. Grab that measuring tape and mark the spots of where you want to drill holes in. Taking this action prevents the drill bit from slipping while you work.
Start the drilling process by placing an “x” with masking or painter’s tape on the tile. Drilling holes in tiles create a stunning, whether it’s in a recently tiled bathroom or perhaps an older one, is indeed a common activity. The clamp (with drill bit wedged in position) is then placed onto the tile so that the drill lines up with the marks previously made on the tile.
Setting the drill to “drill” setting (not “hammer”). Drill very slowly into the tile and the masonry head will work its way through with a neat hole. When wanting to know how to drill into tiles safely, using the right drill bit is very important.
Install the proper drill bit. Drill carefully to break through the surface, then continue with a consistent speed until you reach the required depth. Cool the drill bit to avoid overheating.
Drilling into tile is necessary for just about everything which attaches towards the side, including fitting equipment for toilet rolls as well as soap bowls to putting in a new bathroom cabinet. Screws cannot go into tile until you create a pilot hole for it. This is done by looking down past the drill bit onto the marks on the tile.
Begin drilling using medium pressure. Drilling into porcelain tiles can be intimidating as it’s an expensive material, but breakage can be avoided by following the correct procedure. If you aren’t comfortable with diy tasks such as this, it’s always worth speaking with a professional.
When in the correct place, the suction cup is engaged by pushing the clamping lever on the holesaw guide down as shown above. Ensure that your drill is not on the hammer setting as this will crack your tile. After creating this shallow hole, submerge the drill bit in a cup cold water to cool it down.
Only apply a slight amount of pressure to the drill once it begins to bore into the tile. Drill carefully to break through the surface, then continue with a consistent speed until you reach the required depth. Use masking tape to make x marks on the tile.
Continue drilling for around 6 seconds at a time. Confirm the depth required and mark the drill bit to the same depth with masking tape. How to drill into tile tiles decorative tile drill.
Changing to a masonry drill bit and drilling through the wall. Pressing too hard may cause the entire surface of the tile to crack. Repeat this process for any other holes.
The first step in drilling your bathroom tile is to measure. Measure to pinpoint drilling location. Using a piece of tape to stop the drill bit slipping.
How to drill into tile tile bathroom master bathroom.